on-wall manifold cabinet
Cabinets are supplied complete and finished in white enamel lacquer finish which does not require any further decoration. If required, the door section can be repainted by others to match specific colour schemes. The backplate is fitted with full length rails to accommodate the floor mixing unit manifold brackets, complete with integral pumpsets. Main flow and return connections can be brought in from the top or bottom through ‘knockouts’ provided or holes can be cut to provide other entry points, including from the rear side.
Each cabinet is fitted with a roll bar at the bottom to facilitate the entry of pipes connecting to the manifold. The door section has a built in telescopic action to allow for variations in wall thickness and any plaster rendering or plasterboard applied to the wall. Telescopic feet allow for height adjustments.
Cabinets are usually mounted directly onto the structural slab and there is sufficient height below the door section to allow for floor construction heights up to 130mm. For floors of a greater depth the cabinet should be raised from the floor by packing or fixing the cabinet to the wall at the required height.
Manifold Cabinet Sizes
Width (mm) Height (mm) Depth (mm)
On-wall manifold cabinet: 120mm Brick thickness suitable for 1 ¼” manifold. Quarter turn latch opening.
- 560 x 650 x 130
- 760 x 650 x 130
- 910 x 650 x 130
- 1060 x 650 x 130
- 1260 x 650 x 130
In-wall manifold cabinet: 120mm Brick thickness suitable for 1 ¼” manifold. Quarter turn latch opening.
- 540 x 630 x 110 expands to 130
- 740 x 630 x 110 expands to 130
- 890 x 630 x 110 expands to 130
- 1040 x 630 x 110 expands to 130
View our Components systems
The design is unmistakably the most important part of any underfloor heating system. Our dedicated design team produces accurate and comprehensive drawings for every system that we install, maximising performance for all our systems, guaranteeing that we will supply the most cost effective and efficient solution for your project.
The control system provides a user interface with your heating system and can be as simple or as complex as your requirements.
Our pipe has a robust, 2mm, five layered polyethylene tube that uses the very latest PE-RT technology. The 2mm thick pipe wall is made up of five separate layers and contains an oxygen barrier to prevent the ingress of water from the pipe into the surrounding screed through condensation and to prevent oxidisation by stopping any ingress of oxygen into the pipe. It comes with a 75 year warranty.
The manifold distributes water from the heating source to the relevant zone. Manifolds will typically have a mixer valve to allow them to mix hot flow water with the cooler return to achieve the reduced temperatures required by underfloor heating.
Cabinets are supplied complete and finished in white enamel lacquer finish which does not require any further decoration.
HIGH EFFICIENCY MANIFOLD PUMPSET
The CircoMax is one of the most advanced pumpset units on the market in the UK. This advanced design is unique to WMS.